guillow flyboy ?

[jinxjx]

Hi, i have a couple questions, I plan to use a light dusting or 2 of krylon satin clear on the tissue after its been shrunk and dried. Do i first glue the rudder and stab on the fuselage, then spray the krylon or do it before ? Also, do i remove any tissue off the bottom rudder edge for the gluing ?.....thank you very much

[kittyfritters]

The answer to your question is Yes. You can do it either way although I prefer to fix the tissue, Krylon, dope or whatever (There are other products you can use to do it.) before I assemble the model. Make sure that you are using UV resistant Krylon especially if you are using colored tissue,

I suggest taking tissue off all mating surfaces that are going to be glued together to make sure the glue sticks to the structure, not the tissue.

KF

[jinxjx]

yea, its gonna be tough because of the stabilizer design with the 3/32 spars in the center, i guess i can take alittle tissue off the trailing edge and very little off the 3/32 spars but theres not much holding the tissue at that point but i guess it can be done....thank you