Help needed finding a tool

[Szyp]

Can anyone suggest a place where I can purchase "hobbyist triangles"- those right angle supports for holding formers square while the glue dries?

[joecrouse]

Angle aluminum stock with some cheap backing cork glued to the two outside sides. (to stand off the aluminum from the glue) and holes drilled to pin through would work rather well I believe.

If you use angle iron you may even be able to get away with not using any pins just some lead weights.

[Szyp]

Thanks. Now why didn't I think of that?

[BillParker]

or.... you can go to walmart in the school supplies section...