Guillow's builder's
how long after putting it on before you can take clamps off?
how before it is dry to 'full strength'?
Have A Nice Day!
Elmer's Glue All Drying Times
-
regular guy
- Posts: 147
- Joined: Wed Dec 07, 2011 6:23 pm
- Location: Southern California Low Desert
-
kittyfritters
- Posts: 734
- Joined: Tue Jan 03, 2006 6:58 pm
- Location: California
Re: Elmer's Glue All Drying Times
In my experience, I find that structures are "handleable" after about 30 minutes of drying time, allowing you to continue with the next step in construction. "Complex" structures, such as sheeted, "D-tube" leading edges, should stay in the clamps or pins for a couple of hours. In any event Elmer's joints should set overnight to develop maximum strength.
Sometimes, when pressed for time, I will force the setting of the glue. If you have the room to put the structure in a 200 degree (F) oven, the glue will, for all practical purposes, set hard in 20 minutes. Don't go over 212 degrees or the water in the glue will boil blowing the joints apart before they set. If you are using plastic clamps make sure they can handle the heat. This applies to Elmer's Professional Carpenter's glues and the TiteBond I, II,and III glues also.
Sometimes, when pressed for time, I will force the setting of the glue. If you have the room to put the structure in a 200 degree (F) oven, the glue will, for all practical purposes, set hard in 20 minutes. Don't go over 212 degrees or the water in the glue will boil blowing the joints apart before they set. If you are using plastic clamps make sure they can handle the heat. This applies to Elmer's Professional Carpenter's glues and the TiteBond I, II,and III glues also.
-
SteveM
- Posts: 498
- Joined: Wed Oct 24, 2007 1:06 pm
- Location: Beaverton, OR
- Contact:
Re: Elmer's Glue All Drying Times
You asked virtually the same question two months ago!
http://balsamodels.com/phpBB/viewtopic. ... 937#p13936regular guy wrote:how long does the Elmer's take to set?
how long does it take to totally dry ?
-
Xanadu
- Posts: 497
- Joined: Wed Sep 27, 2006 9:48 pm
- Location: Anola, MB, Canada
Re: Elmer's Glue All Drying Times
I thought I heard an echo.
-
regular guy
- Posts: 147
- Joined: Wed Dec 07, 2011 6:23 pm
- Location: Southern California Low Desert
Re: Elmer's Glue All Drying Times
kitty fritters
i was skimming through Don Ross's second book 'Flying Model Plane's'.
in glue section he says to put parts glued with basically wood glues in the oven.
he says it makes glue even stronger.
so you're suggestion is not as off the wall as it sounds at first.
Have A Nice Day!
i was skimming through Don Ross's second book 'Flying Model Plane's'.
in glue section he says to put parts glued with basically wood glues in the oven.
he says it makes glue even stronger.
so you're suggestion is not as off the wall as it sounds at first.
Have A Nice Day!