Detailing
-
Coloradoken
- Posts: 114
- Joined: Wed Sep 24, 2014 9:40 am
Detailing
Just finishing up a P38M Night Lightning and am getting ready to add the the thin lines outlining control surfaces, sheet metal joints, etc. Its always a problem trying to hold the model steady while holding a straight edge and another hand applying the ink. Any good suggestions?
-
Bluesynk
- Posts: 33
- Joined: Tue Nov 10, 2015 2:27 pm
Re: Detailing
Painters tape. Use as a straight edge. You can triple it up and reuse it. Fits curves, holds itself. Detac as necessary.