Guillows Dr.1

dbcisco · Post by **dbcisco** » Fri Oct 30, 2009 9:05 pm

I had to do this one in red Coverlite. No electronics installed yet.

svaughn · Post by **svaughn** » Sat Oct 31, 2009 11:26 am

Beautiful!

What is it covered with?

Xanadu · Post by **Xanadu** » Sat Oct 31, 2009 11:33 am

I had to do this one in red Coverlite. No electronics installed yet. [quote][/quote]

dbcisco · Post by **dbcisco** » Sat Oct 31, 2009 11:41 am

The red translucent Coverlite was used with a dusting of Testors flat red enamel spray paint to get rid of the shine. Bottom of wings is blue.

svaughn · Post by **svaughn** » Sat Oct 31, 2009 11:46 am

Sorry I can't read. It came through as Corvette Red to me. Have to get my eyes checked.

It looks like a really amazing tissue cover, but the finish is so smooth.

Does Coverlite shrink or stretch?

Are there more pictures of models done in Coverlite around?

dbcisco · Post by **dbcisco** » Sat Oct 31, 2009 12:11 pm

It shrinks with heat, very little heat so you need to be careful. Probably would work better with a hair dryer than my heat gun. Will try that on my next one. My Morse Scout that is posted here in another thread is coverlite also. The only problem with coverlite is that even after a light dusting of enamel spray paint, it has to be re-heat shrunk.

dbcisco · Post by **dbcisco** » Sat Oct 31, 2009 2:56 pm

Correction on the covering. It is Microlite (by Coverite). Very light. The Morse Scout is done with Black Baron by Coverite. A bit heavier and more tension when shrunk.

cliffm · Post by **cliffm** » Sat Oct 31, 2009 7:26 pm

Nicely done! Which mailorder house can I order the covering? Got a website?

dbcisco · Post by **dbcisco** » Sat Oct 31, 2009 8:19 pm

I got it at the local hobby shop. Google "coverlite" see if a dealer is near you.